生成时钟频率的问题？

输出通常是方波。检查你正在使用的电路板的原理图，看看是否有一个用于缓冲的管脚上的盖子。看起来有点像这样。你使用哪一个板，你的输出被发送到哪个端口？PIN是如何配置的？？
请您发布完整的项目或缩短的版本，以显示错误，以便我们都可以查看您的所有设置。为此，使用
创建者-gt；文件& gt；创建工作区束（最小）
并附加生成的文件。
鲍勃



以下为原文
The output is usually a square wave. Check the schematic of the board you are using whether there is a cap on the pin for buffering. Looks a bit as if so. Which Board are you using and which port your output is sent to? How is the pin configured??

Can you please post your complete project or a shortened version that shows the error so that we all can have a look at all of your settings. To do so, use
Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file.

Bob

它也可以是示波器探头问题。在10X模式下使用探针。您也可以尝试调整探头补偿。
-拉吉夫



以下为原文
It could also be a oscilloscope probe issue. Use the probe in 10x mode. You can also try adjusting the probe compensation.

-Rajiv

您好，我配置的输出引脚作为一个拉，这个引脚直接连接到时钟这个时钟是49 MHz的主时钟和除法器7，我采取7兆赫的输出，但不是锋利的值或图形不是一个平方波。



以下为原文
HELLO i am configuring the output pin as a pull up and and this pin is directly connected to clock this clock is 49mhz master clock and divider by 7 i am taking the 7 mhz output but not the sharp value or graph is not an squre wave.

我也尝试过这一切都不会发生变化。



以下为原文
i was also try this nothing change will be happen.

你好，
您需要将PIN驱动模式设置为“Stand”。
-拉吉夫



以下为原文
Hi,

You need to set the pin drive mode to "strong".

-Rajiv

我已经做过了。没什么变化，我会用LP05试剂盒。



以下为原文
i was already done this.nothing change it will happen.and i am using lp05 kit.