我的PSoC 5LP评估板CYC8KIT-050无法启动和编程

你好，
我尝试使用12位SAR ADC，并且我没有注意到系统是在3.3V模式，并且为了测试，我已经连接了5V到ADC的输入。一段时间后，我看到评估板的LeD4和LeD3开始发光，PSoC芯片变热了。我关掉了。之后，每当我试图连接 电源时，LeD4和LeD3都发光，PSoC代码不启动。即使我也不能闪亮新代码。我也尝试使用MixPrim3，但没用。
请建议仍然可以固定或董事会不见了。当我正在连接时，我得到下面的屏幕（下面附上）
谢谢您。
当做，
扎法尔
PNG
106.5 K



以下为原文
Hi,

I was trying to use 12 bit SAR ADC, and I did not no tice that the system was in 3.3v mode and for testing I have connected 5v to the input of ADC. After some time I saw the LED4 and LED3 of the evalaution board started glowing and the PSoC chip became hot. I switched off. After that everytime whenever I am trying to connect to power supply both of the LED4 and LED3 is glowing and PSoC code is not booting. Even I am not able to flash the new code. I tried using miniprog3 also but it did not help.

Please suggest still this can be fixed or the board is gone. When I am connecting I am getting following screen (attached below)


Thank you.

Regards,
Zafar

• Debug_Mode.PNG106.5 K