escape_seq参数在IDW01M1中无法正常工作

你好ST，
似乎escape_seq参数在IDW01M1中无法正常工作。
用户手册与获得的结果之间存在一些差异。请看一下我的成绩单：
12：16：15.761 [TX] - at + s.scfg = escape_seq，at + miao＆lt; CR＆gt;
12：16：26.101 [RX] - 好的
+ WIND：61：传入套接字客户端：192.168.0.218
+ WIND：60：现在处于数据模式
12：25：49.307 [TX] - at + miao
12：25：49.807 [RX] - + WIND：59：返回命令模式
12：26：05.899 [TX] - at + miao
12：26：10.363 [TX] - at + miao＆lt; CR＆gt;
12：26：13.700 [TX] -AT + S.＆lt; CR＆gt;
12：26：13.703 [RX] - + WIND：60：现在处于数据模式
所以，似乎：
1）escape_seq仅更改data-＆gt;命令序列，但不更改command-＆gt;数据
2）在命令模式下，你需要发送一个来激活序列，尽管手册说明了相反的情况。
更多信息：
♯nv_model= SPWF01SA1
♯nv_serial= 3915D31697
♯版本= 160129-c5bf5ce-SPWF01S
朱塞佩

#x-nucleo-idw01m1＃spwf01sa1＃escape-sequence



以下为原文




Hello ST,
it seems that the escape_seq parameter does not work as expected in the IDW01M1.
There are some discrepancies between the user manual and the obtained results. Please have a look at my transcript:
12:16:15.761 [TX] - at+s.scfg=escape_seq,at+miao
12:16:26.101 [RX] - OK
+WIND:61:Incoming Socket Client:192.168.0.218
+WIND:60:Now in Data Mode
12:25:49.307 [TX] - at+miao
12:25:49.807 [RX] - +WIND:59:Back to Command Mode
12:26:05.899 [TX] - at+miao
12:26:10.363 [TX] - at+miao

12:26:13.700 [TX] - AT+S.
12:26:13.703 [RX] - +WIND:60:Now in Data Mode
So, it seems that:
1) escape_seq only changes the data->command sequence, but not the command->data
2) when in command mode, you need to send a to ac tivate the sequence, despite the fact that the manual states the opposite.
Some more information:
♯ nv_model = SPWF01SA1
♯ nv_serial = 3915D31697
♯ version = 160129-c5bf5ce-SPWF01S
Giuseppe

#x-nucleo-idw01m1 #spwf01sa1 #escape-sequence

0