Hi,
Kindly assist here. Our oscilloscope is giving error. "_No trigger or trigger bandwidth set
ting incorrect. Please check trigger bandwidth setting"_
I have tried to re connect the trigger, vary the bandwidth, reset the scope but bore no fruits. The same message still appears.
Attached is a picture of the error message. Has anyone seen this problem before on 86105C oscilloscope?
These are both perfect questions for your local Keysight Technical Call Center. There is a lot of information that would be needed to be asked, before an answer is possible.
Go to Keysight.com, enter your product number. Once a page come up, Click the "Contact an Expert" link.