PIC32以太网入门套件2 TCPIP DISCOVERER IP检测问题

我已经把DP838 48 PHY.C文件改成LAN840.C，但是我不能在TCPIIPIONDEMENER中获取IP地址。



以下为原文

I have changed the DP83848 PHY.c file to lan8740.c, however i am not able to get the ip address in tcp_ip_discoverer.

有两种配置，你可以做到：要点是把你的PC和PIC放在同一子网下。1）把静态IP分配给你的以太网卡：你可以从Windows控制面板上做，你必须把你的IP放在微控制器的同一子网下。EX:如果分配给PIC的IP是192.168100.10，那么你必须给你的PC的IP是192.168100.x（EX:X＝15），子网掩码是255.255.255.0和网关192.168100.1。然后，你必须打开你的浏览器并输入PIC的IP。2）让PIC从DHCP服务器请求一个动态IP：在这个配置中，PIC必须配置为DHCP客户端，你不必对你的PC以太网卡进行控制，把它放在动态IP上，但是你必须使用一个路由器。图中的路由器，并连接您的PC和PIC到路由器的局域网端口。然后，你必须进入路由器配置来检查PIC的IP，然后，你可以从你的浏览器中启动PIC的IP。对于和谐的配置，我遵循TCP/IP硕士课程PDF的微芯片。谢谢。



以下为原文

There are two configurations that you can do:

The point is to put your PC and the PIC under the same subnet.

1) Assign Static IP to your ethernet card:
You can do it from control panel from windows and you have to put your IP under the same subnet of the microcontroller. ex: if the IP assigned to the PIC is 192.168.100.10, the ip that you have to give to your PC is 192.168.100.x (ex: x=15), subnet mask is 255.255.255.0 and the gateway 192.168.100.1 . Then, you have to open your browser and enter the IP of the PIC. (disable any other network connection first like wifi,..etc).

2) Let the PIC ask for a dynamic IP from DHCP server:
In this configuration the PIC have to be configured as DHCP client, you don't have to cinfigure your PC ethernet card, leave it on Dynamic IP, but you have to use a router.
You have to configure the router and connect your PC and the PIC to the LAN ports of the router. Then, you have to enter to the router configration to check the IP of the PIC and then, you can proceed from your browser, enetering the PIC's IP.

For the configuration of the HARMONY, i followed the TCP/IP master course PDF of MICROCHIP.

Thanks.

发现者和我也不合作，IDK为什么，但是我可以看到WiRaskKeNoK上的数据包：我使用PIC32以太网SK 1



以下为原文



The discoverer isn't working with me also, idk why but i can see the packets on wireshark
Note: I am using PIC32 Ethernet SK 1

嗨，我通过Microchip技术支持获得了早期版本2017的TCPIP发现者的另一个版本。



以下为原文

Hi,
I received through Microchip technical support another version of TCPIP discoverer early 2017.
Find it herewith.
change the .txt extension into .zip
Regards
Attachment(s)

tcpip_discoverer_v2.5_170622.txt (77.88 KB) - downloaded 33 times

在我的和谐安装中，我找到了版本2.6（和源目录），它是在Java中。



以下为原文

In my Harmony installation at
I find version 2.6 ( and a source directory ), it is in java.