连接到N8241A Via Lan收到超时错误

您好，我正在尝试设置AWG，并且我在第一次连接设备时遇到问题。
按照手册中的“入门”部分，我已经安装了IVI Compliance Package，IO Libraries Suite和设备驱动程序（我们的CD放错了位置，我直接从N8241A页面下载了驱动程序）。
我试图通过LAN连接到设备。
我的电脑通常有静态IP。
我删除了，因此没有与我的电脑相关联的IP地址。
我通过以太网将设备直接连接到我的计算机。
打开Keysight Connec tion Expert，我正在尝试添加新的LAN仪器。
我输入了设备上找到的主机名，并将TCPIP接口ID保留为默认值（TCPIP0）。
协议保留在默认的“Instrument”中，远程名称为“inst0”。
但是，测试VISA地址时，我只会收到超时错误。
我的问题是 - 我是否需要将设备连接到网络才能正确访问它？
此网络上没有DHCP，如果是这样，有没有办法静态地为设备分配一个？
否则，可能导致我的连接问题的其他因素是什么？
谢谢你，FrenchyRaoul



以下为原文

Hello,

I'm trying to get an AWG set up, and I am having issues getting the device connected for the first time. Following the Getting Started section in the manual, I have installed the IVI Compliance Package, the IO Libraries Suite, and the driver for the device (our CD was misplaced, I downloaded the driver directly from the N8241A page). I am trying to connect to the device via LAN.

My computer normally has a static IP. I deleted that, so there is no IP address associated with my computer. I have the device connected directly to my computer via Ethernet. Opening Keysight Connection Expert, I am trying to add a new LAN instrument. I have entered the hostname found on the device, and left the TCPIP Interface ID at the default (TCPIP0). The protocol is left at the default 'Instrument', with remote name 'inst0'. Testing the VISA address, however, I just get a timeout error.

My questions are- do I need to connect the device to the network in order to properly access it? There is no DHCP on this network, so if so, is there a way to statically assign one to the device? Otherwise, what other factors might be causing my connection issues?

Thank you,
FrenchyRaoul