你好,
我们的目的是将CasSooLoad片段弯曲形状(如附录中所示),并有以下查询。
1 &是否有任何指南文件可用于沿曲线路径放置滑块段?
2、是否所有的滑块都必须等尺寸?
3对滑块段的接地网宽度是否有要求?由于我们打算把滑块靠近板边缘,并有非常小的空间为地面网格一侧。
4滑块轨迹与10密耳间隙平行(在它们之间没有接地网)?
5和gt;在图像的一个侧面放置CasSook IC可以吗?
谢谢,
毗沙尔
滑块布局
377.3 K
以上来自于百度翻译
以下为原文
Hello,
We are intended to place capsense slider segments in curved shape ( as shown in attached file ) and have below queries.
1> Is there any guideline document available to place slider segment along curved path ?
2> Is it must to have all slider segments in equal dimension ?
3> Is there any requirement on width of the ground mesh around slider segment ? As we intend to place slider close to board edge, and have very small room for ground mesh on one side.
4> Can slider trace run parallel with 10 mil clearance in between ( No ground mesh in between them) ?
5> is it Ok to place capsense IC on one side of slider , as shown in image ?
Thanks,
Vishal
0