电机控制工作台SDK V5.1.1标称电流和预期过电流阈值如何设置

你好，
1.额定电流是否仅用于调节电动机的最大电流（即转矩），但对过电流保护没有任何作用？
2.预期的过流阈值是否只是根据您输入的当前网络偏移和当前网络增益计算的值？实际截止电流取决于 电路上的电阻值和比较器阈值设置？所以，如果我是对的，硬件保持不变，比较器有相同的设置，即使我改变网络偏移，工作台中的增益也不会影响实际的电流保护阈值？

3.什么过流保护禁用网络及其极性？
谢谢

＃motor-control-workbench-sdk-v5.1.1 #oc_comp #oc_sel＃octh_stby2_pin | octh_stby1_pin＃oc-calcula tion＃spin3201＃v5.1.1 #sdk-5＃over-current



以下为原文




Hi there,
1. Does the nominal current only used to regulate the maximum current(ie torque) of the motor but do nothing about over current protection?
2.Is the expected over current threshold only a value calculated from the current network offset and current network gain you input for reference? The actually cut off current is depending on the resistor values on your circuit and comparator threshold setting? So if I am right, the hardware remains same and comparator has same setting, even I change the network offset and gain in the workbench won't affect the real current protection threshold?

3.And what over-current protection disabling network and its polarity?
Thanks

#motor-control-workbench-sdk-v5.1.1 #oc_comp #oc_sel #octh_stby2_pin|octh_stby1_pin #oc-calculation #spin3201 #v5.1.1 #sdk-5 #over-current