Agilent 6651A故障操作

您好，我对Agilent 6651A 电源的故障操作有疑问（请参阅操作手册第123页）。
与故障相关的引脚在数字端口连接器上为1和2。
我被agilent apps eng告知，必须对故障状态进行编程，以使引脚按照手册中的说明运行，但在手册中描述“出厂时，数字端口配置为提供故障
指示灯（FLT）输出和远程（INH）输入。“
此外，跳线在引脚7和8上处于故障/禁止设置。如果我试图使用引脚1和2进行故障操作，我必须编程故障条件或没有编程任何东西，我可以去
通过短接引脚3和4来保护模式以禁止和触发故障？
应用：我正在尝试使用外部12V（类似于手册的图D-3所示）运行外部继电器，并尝试使用引脚1和2作为开关。
参见附图。
这将是伟大的，如果任何有直接亲身经验的人都可以提供帮助。
谢谢，帕维特编辑：cooltools于2014年3月11日下午6:52编辑：cooltools于2014年3月13日下午12:48编辑者：cooltools于2014年3月13日下午12:53



以下为原文

Hello,

I have a ques tion regarding the fault operation of Agilent 6651A power supply (refer to pg 123 of the operating manual). The pins related to fault are 1 and 2 on digital port connector.

I was told by agilent apps eng that fault condition has to be programmed, in order for the pins to function as described in the manual but in the manual it is described "As shipped from the factory, the digital port is configured to provide a fault indicator (FLT) output and a remote (INH) input." Also, the jumpers are in fault/inhibit setting on pins 7 and 8.

Is it true that if i am trying to use pins 1 and 2 for fault operation, that i have to program the fault conditions or without programming anything, i could go in a protect mode by shorting pins 3 and 4 for inhibit and trigger fault?

Application: i am trying to run an external relay with an external 12V (similar to shown in fig. D-3 of the manual) and trying to use pins 1 and 2 as a switch. See the attached schematic.

It would be great, If anyone with direct hands on experience can help.

Thanks,
Pavit

Edited by: cooltools on Mar 11, 2014 6:52 PM

Edited by: cooltools on Mar 13, 2014 12:48 PM

Edited by: cooltools on Mar 13, 2014 12:53 PM
附件

• Agilent 6551A schematic for light pins1-2.JPG80.4 KB