当我在NFig模式下使用E44446A Spec时,每次扫描的扫描速率> 6秒,11个频率点。
这是合理的 - 可以设置得更快吗?
在NFig Meas模式下,E44446A配置为1)输入调谐频率:750M至1250M,11点2)平均OFF;
RBW =“自动”(设置为1MHz)2)内部前置放大器ON(选项1DS)4)下变换器MOde 4)被测器件;
通常NFig> 12dB,增益> 24dB。
5)噪声源:15dB ENR。
NFig Meter模式比频谱分析仪模式慢3个数量级。
这是否合理?
有没有办法在规格分析仪模式下手动控制扫描速率。
在NFig模式中,扫描速率为“灰显”,即禁用。
以上来自于谷歌翻译
以下为原文
When I use the E44446A Spec in NFig mode, the sweep rate is > 6 seconds per sweep, for 11 freq points. is this reasonable - can it be set faster?
In NFig Meas Mode, the E44446A config is
1) Input tuned freq: 750M to 1250M , 11 points
2) Average OFF; RBW ="Auto" (set at 1MHz)
2) Internal pre amp ON (Op
tion 1DS)
4) Down Converter MOde
4) Device Under Test; typically NFig > 12dB, gain > 24dB.
5) Noise source : 15dB ENR.
The NFig Meter mode is 3 orders of magnitude slower than the spectrum analyzer mode. Is this reasonable.
Is there a way to manually control the sweep rate as in spec analyzer mode. In NFig mode, the sweep rate is 'grayed out", i.e disabled.
0