嗨 - 如果不首先执行高压调整,某些显示调整将不会得到很好的优化。
确认已完成高压调整后,请执行显示调整,尤其是偏转调整。
在进行偏转调整时,可能有助于稍微降低强度,特别是对于DGTL X GAIN和DGTL Y GAIN调整。
这些是你试图使实际上两条线汇合成一条线的调整。
如果强度太高,则更难以使此调整正确。
这些调整以及START BLANK和STOP BLANK调整将影响这些下划线的显示方式。
如果这些调整无法使下划线显示正确,则可能是CRT本身存在问题。
假设零件本身可用,这可能是代价高昂的替代品。
问候 -
以上来自于谷歌翻译
以下为原文
Hi -
If the High Voltage Adjustment is not performed first, some of the Display Adjustments will not be as well-optimized. After you have verified that the High Voltage Adjustments have been done, do the Display Adjustments, especially the Deflection Adjustments. When doing the deflection adjustments, it might help to reduce the intensity somewhat, especially for the DGTL X GAIN and DGTL Y GAIN adjustments. These are the adjustments where you are trying to make what are actually two lines converge into one. If the intensity is too high, it is more difficult to get this adjustment correct. These adjustments, along with the START BLANK and STOP BLANK adjustments, will impact how those underlines appear.
If these adjustments are unable to make the underlines appear correct, you might have a problem with the CRT itself. This can be a costly replacement, assuming the part itself is available.
Regards -