CY8CKIT-023无法编程

023工具包是一个扩展板，因此它不会被编程。相反，在001板上的处理器模块是目标。这就是你必须选择的芯片。如果这不是您尝试运行的第一个项目，请从上一个工作项目中获取设置。
将MILPROG 3连接到SWD连接器和USB。选择（在工具下）。-/gt；程序/调试-gt；端口配置-gt；MimPROG 3 SWD接口10引脚，选择您的电源（主要是外部）。
现在，通过调试菜单获得完全控制，不需要明确地“编程”您的设备，这是自动完成的。
当选择调试-gt；选择目标时，您将看到带有附加设备的MIXPROP3。在运行另一个“清洁和构建”之前，应选择此选项。
鲍勃



     以下为原文
  The -023 kit is an expansion board, hence it will not be programmed. Instead the processor-module on the -001 board is the target. So this is the chip you have to select. If this is not the first project you try to run, take the settings from your last working project.
    Connect the Miniprog 3 to the swd connector and to USB. Select (under tools -> Options.. -> Program/Debug-> Port Configuration -> Miniprog 3 the SWD interface 10 pin, select your powering accordinglly (mostly external).
    Now you get full control via the Debug - menu, no need to explicitly "Program" your device, that is done automatically.
    When you select Debug -> Select Target you will see your Miniprog3 with the attached device. This you should select before you run another "Clean and Build"
     
    Bob

我分配了所有这些，但我仍然不能编程8C3666 AXI-40。端口获取连接按钮不存在。不是连接按钮，“设备已被识别，但PSoC Creator此时不支持使用它。”消息发生。因为我使用的是创造者2.1，我不能改变ES。
我该怎么处理呢？
谢谢。



     以下为原文
   I assigned all of these, but still I cannot program [size=10.909090995788574px]CY8C3866AXI-40. Connect button on the port acquire does not exist. Instead of connect button, "The device was recognized, but PSoC Creator does not support using it at this time." message occured. Since I am using Creator 2.1, I cannot change ES.
    How can I handle with this?
    Thanks.

创建者2.1放弃支持PSoC3ES版本，它只支持生产硅。检查发行说明-我认为版本2可能仍然支持ES2版本。
有一个程序来交换旧的PSoC3板生产硅：wwwyCyp.com /所以也许这有助于你…



     以下为原文
  Creator 2.1 dropped support for PSoC3 ES version, it only supports production silicon. Check the release notes - I think version 2.0 might still support ES2 versions.
    There is a program to exchange old PSoC3 board to production silicon: www.cypress.com/ so maybe this helps you...