[问答]

擦除整个flash（ idf.py -p COM5 erase_flash）后下载程序报phy_init: failed to load RF calibration data (0x1102)后重启怎么解决？

252 Load

问答对人有帮助，内容完整，我也想知道答案 0 Rebooting... ets Jun 8 2016 00:22:57 rst:0xc (SW_CPU_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT) configsip: 0, SPIWP:0xee clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00 mode:DIO, clock div:2 load:0x3fff0018,len:4 load:0x3fff001c,len:6316 load:0x40078000,len:11624 load:0x40080400,len:6648 entry 0x40080764 I (29) boot: ESP-IDF v3.3 2nd stage bootloader I (29) boot: compile time 14:06:08 I (29) boot: Enabling RNG early entropy source... I (33) boot: SPI Speed : 40MHz I (38) boot: SPI Mode : DIO I (42) boot: SPI Flash Size : 4MB I (46) boot: Partition Table: I (49) boot: ## Label Usage Type ST Offset Length I (56) boot: 0 nvs WiFi data 01 02 00009000 00006000 I (64) boot: 1 phy_init RF data 01 01 0000f000 00001000 I (71) boot: 2 coredump Unknown data 01 03 00010000 00010000 I (79) boot: 3 factory factory app 00 00 00020000 00140000 I (86) boot: 4 ota_0 OTA app 00 10 00160000 00140000 I (94) boot: 5 ota_1 OTA app 00 11 002a0000 00140000 I (101) boot: 6 otadata OTA data 01 00 003e0000 00002000 I (109) boot: End of partition table I (113) boot: Defaulting to factory image I (118) esp_image: segment 0: paddr=0x00020020 vaddr=0x3f400020 size=0x39b5c (236380) map I (210) esp_image: segment 1: paddr=0x00059b84 vaddr=0x3ffbdb60 size=0x03718 ( 14104) load I (216) esp_image: segment 2: paddr=0x0005d2a4 vaddr=0x40080000 size=0x00400 ( 1024) load 0x40080000: _WindowOverflow4 at D:/espressif/esp-idf-v3.3/components/freertos/xtensa_vectors.S:1779 I (217) esp_image: segment 3: paddr=0x0005d6ac vaddr=0x40080400 size=0x02964 ( 10596) load I (230) esp_image: segment 4: paddr=0x00060018 vaddr=0x400d0018 size=0xe60b4 (942260) map 0x400d0018: _flash_cache_start at ??:? I (565) esp_image: segment 5: paddr=0x001460d4 vaddr=0x40082d64 size=0x13830 ( 79920) load 0x40082d64: _xt_coproc_exc at D:/espressif/esp-idf-v3.3/components/freertos/xtensa_vectors.S:1064 I (612) boot: Loaded app from partition at offset 0x20000 I (612) boot: Disabling RNG early entropy source... I (612) cpu_start: Pro cpu up. I (616) cpu_start: Application information: I (621) cpu_start: Project name: esp-idf I (625) cpu_start: App version: v3.3 I (630) cpu_start: Compile time: Jun 3 2020 14:06:04 I (636) cpu_start: ELF file SHA256: d40f1425bd822b7e... I (642) cpu_start: ESP-IDF: v3.3 I (647) cpu_start: Starting app cpu, entry point is 0x40081108 0x40081108: call_start_cpu1 at D:/espressif/esp-idf-v3.3/components/esp32/cpu_start.c:270 I (639) cpu_start: App cpu up. I (658) heap_init: Initializing. RAM available for dynamic allocation: I (664) heap_init: At 3FFAFF10 len 000000F0 (0 KiB): DRAM I (670) heap_init: At 3FFB6388 len 00001C78 (7 KiB): DRAM I (677) heap_init: At 3FFB9A20 len 00004108 (16 KiB): DRAM I (683) heap_init: At 3FFBDB5C len 00000004 (0 KiB): DRAM I (689) heap_init: At 3FFCE6E0 len 00011920 (70 KiB): DRAM I (695) heap_init: At 3FFE0440 len 00003AE0 (14 KiB): D/IRAM I (701) heap_init: At 3FFE4350 len 0001BCB0 (111 KiB): D/IRAM I (708) heap_init: At 40096594 len 00009A6C (38 KiB): IRAM I (714) cpu_start: Pro cpu start user code I (61) cpu_start: Chip Revision: 1 W (62) cpu_start: Chip revision is higher than the one configured in menuconfig. Suggest to upgrade it. I (65) cpu_start: Starting scheduler on PRO CPU. I (0) cpu_start: Starting scheduler on APP CPU. SDK version:v3.3 I (77) system_api: Base MAC address is not set, read default base MAC address from BLK0 of EFUSE I (87) app_main: mac:246F289D0A8C I (127) sc: led_show I (127) sc: RAM bytes left 188248 I (127) BTDM_INIT: BT controller compile version [e736f10] I (127) sc: The current date/time in china is:5 I (137) system_api: Base MAC address is not set, read default base MAC address from BLK0 of EFUSE Done I (137) sc: The current date/time in china is:101080005 Restart counter = 0 W (147) phy_init: failed to load RF calibration data (0x1102), falling back to full calibration ADC channel 7 @ GPIO 35, DAC channel 1 @ GPIO 25. I (167) wifi: wifi driver task: 3ffd56dc, prio:23, stack:3584, core=0 I (167) system_api: Base MAC address is not set, read default base MAC address from BLK0 of EFUSE I (177) system_api: Base MAC address is not set, read default base MAC address from BLK0 of EFUSE I (217) wifi: wifi firmware version: aeed694 I (217) wifi: config NVS flash: enabled I (217) wifi: config nano formating: disabled I (217) wifi: Init dynamic tx buffer num: 32 I (217) wifi: Init data frame dynamic rx buffer num: 32 I (227) wifi: Init management frame dynamic rx buffer num: 32 I (227) wifi: Init management short buffer num: 32 I (237) wifi: Init static rx buffer size: 1600 I (237) wifi: Init static rx buffer num: 10 I (237) wifi: Init dynamic rx buffer num: 32 ESP_ERROR_CHECK failed: esp_err_t 0x5 (ERROR) at 0x40091ca0 0x40091ca0: _esp_error_check_failed at D:/espressif/esp-idf-v3.3/components/esp32/panic.c:720 file: "../main/smartconfig_main.c" line 990 func: wifi_init expression: esp_wifi_set_config(ESP_IF_WIFI_STA, &wifi_config) ELF file SHA256: d40f1425bd822b7eec83fd57d51dc27135569621db494dda3f4439ee178e313e Backtrace: 0x40091838:0x3ffd04b0 0x40091ca3:0x3ffd04d0 0x400d4536:0x3ffd04f0 0x400d48f6:0x3ffd0640 0x4008dee9:0x3ffd0670 0x40091838: invoke_abort at D:/espressif/esp-idf-v3.3/components/esp32/panic.c:715 0x40091ca3: _esp_error_check_failed at D:/espressif/esp-idf-v3.3/components/esp32/panic.c:721 0x400d4536: wifi_init at D:espressifesp-idf-v3.3gatt_server_modify_otabuild/../main/smartconfig_main.c:990 (discriminator 1) 0x400d48f6: wifi_main at D:espressifesp-idf-v3.3gatt_server_modify_otabuild/../main/smartconfig_main.c:1279 0x4008dee9: vPortTaskWrapper at D:/espressif/esp-idf-v3.3/components/freertos/port.c:403 0
2023-3-13 09:19:40　　评论淘帖0 邀请回答您可以邀请以下用户，快速回答问题 × wang21cj 该类别下有 38 个回答。邀请回答 hgimtk 该类别下有 38 个回答。邀请回答新星之火12138 该类别下有 33 个回答。邀请回答 chm5 该类别下有 32 个回答。邀请回答 zyh34997 该类别下有 32 个回答。邀请回答就好国dd 该类别下有 32 个回答。邀请回答 zaichenxi 该类别下有 31 个回答。邀请回答 heks 该类别下有 31 个回答。邀请回答四川赵赵该类别下有 29 个回答。邀请回答 flowerddd 该类别下有 29 个回答。邀请回答 muwersddg 该类别下有 29 个回答。邀请回答 caosurround 该类别下有 28 个回答。邀请回答星星公交站该类别下有 28 个回答。邀请回答 vinww特烦恼该类别下有 28 个回答。邀请回答 lkjflksjfsa 该类别下有 27 个回答。邀请回答 h1654155143.8331 该类别下有 27 个回答。邀请回答 723662364d 该类别下有 27 个回答。邀请回答 overheat 该类别下有 27 个回答。邀请回答 gvjhvbc 该类别下有 27 个回答。邀请回答安德森大该类别下有 27 个回答。邀请回答举报刘丽相关推荐 • 设置按钮后报phy_init: failed to load RF calibration data怎么解决？ 293 • esp32c3FN4制作板子烧录后报错不断重启的怎么解决？ 168 • 捣鼓wifi softAP在初始化时出现phy_init错误是怎么回事啊？ 135 • ESP32 C3校准参数问题如何解决？ 256 • ESP32 WROOM-32下载wifi station示例，一直重启的原因？ 159 • ESP32 WROOM-32下载wifi station示例一直重启的原因？怎么解决？ 163 • ESP32-C3使用WIFI_STA例程卡死在初始化(phy_init:)怎么解决？ 436 • ESP32-DevKitc开发板烧写突然异常导致无法烧写怎么解决？ 285 • 运行idf.py -p COM4 flash monitor出错是什么原因导致的？ 174 • ESP32-C3-DevKitM-1出现Invalid head of packet (0x47)问题无法烧录怎么解决？ 185