资料介绍
The TRS3223 consists of two line drivers, two line receivers, and a dual charge-pump circuit with ±15-kV ESD protection pin to pin (serial-port connection pins, including GND). The device meets the requirements of TIA/EIA-232-F and provides the electrical interface between an asynchronous communication controller and the serial-port connector. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-V supply. The device operates at data signaling rates up to 250 kbit/s and a maximum of 30-V/µs driver output slew rate.
Flexible control options for power management are available when the serial port is inactive. The auto-powerdown feature functions when FORCEON is low and FORCEOFF is high. During this mode of operation, if the device does not sense a valid RS-232 signal, the driver outputs are disabled. If FORCEOFF is set low and EN is high, both drivers and receivers are shut off, and the supply current is reduced to 1 µA. Disconnecting the serial port or turning off the peripheral drivers causes auto-powerdown to occur. Auto-powerdown can be disabled when FORCEON and FORCEOFF are high. With auto-powerdown enabled, the device is activated automatically when a valid signal is applied to any receiver input. The INVALID output is used to notify the user if an RS-232 signal is present at any receiver input. INVALID is high (valid data) if any receiver input voltage is greater than 2.7 V or less than -2.7 V, or has been between -0.3 V and 0.3 V for less than 30 µs. INVALID is low (invalid data) if the receiver input voltage is between -0.3 V and 0.3 V for more than 30 µs.
- 带±15 kV ESD保护的3V至5.5V多通道RS-232线路驱动器/接收器TRS3223E 数据表
- MAX3222 3-V和5.5-V多通道RS-232线路驱动器和接收器数据表
- MAX3223E,pdf(3-V to 5.5-V Mult
- MAX3227E,pdf(3-V to 5.5-V Sing
- MAX3238E,pdf(3-V TO 5.5-V Mult
- TRS3221,pdf(3-V to 5.5-V Singl
- TRS3222,pdf(3-V to 5.5-V Multi
- TRS3223-Q1,pdf(3-V To 5.5-V Mu
- TRS3227,pdf(3-V to 5.5-V Singl
- TRS3232,pdf(3-V to 5.5-V Multi
- TRS3238,pdf(3-V to 5.5-V Multi
- TRS3223E,pdf(3-V TO 5.5-V MULT
- TRS3227E,pdf(3-V TO 5.5-V SING
- TRS3238E,pdf(3-V TO 5.5-V MULT
- TRSF3238E,pdf(3-V to 5.5-V Mul
- 基于晶体管的低压差5V/12V稳压电路 3184次阅读
- 1.5V/3V/6V逆变器电路图分析 4107次阅读
- 42V四通道单芯片同步降压型稳压器用于工业和汽车应用 1035次阅读
- TIA V16与STEP 7 V5.5控制面板对比 1744次阅读
- TIA V16与STEP 7 V5.5PID控制面板对比 1784次阅读
- 3V到9V直流转换器的电路图分享 3530次阅读
- 3V-30V/3A可调稳压电源电路图 1.2w次阅读
- dfrobotDC-DC降压电源模块5.5~28V转3.3V3A介绍 3456次阅读
- 如何将15V转换为3V输出 6307次阅读
- AQH3223光电耦合器的特点及应用 1.4w次阅读
- 5V转3.3V如何设计方案? 3990次阅读
- 超小型5.5V DC/DC降压电源模块具备真6A性能 8839次阅读
- 3v和5v双向电平怎么转换电路 14.4w次阅读
- 超基础的3V-5V电平转换电路图设计 1.1w次阅读
- 3V-5V电平转换电路图 4316次阅读
下载排行
本周
- 1BT134双向可控硅手册
- 1.74 MB | 2次下载 | 1 积分
- 2使用TL431设计电源
- 0.67 MB | 1次下载 | 免费
- 3LabVIEW环形控件
- 0.01 MB | 1次下载 | 1 积分
- 404-01-02-CBM317线性稳压器(LDO)
- 2.01 MB | 1次下载 | 免费
- 5BP2879DB支持调光调灭的非隔离低 PF LED 驱动器
- 1.44 MB | 1次下载 | 免费
- 6CBMuD1200_CBMuD1201数字隔离器
- 757.44 KB | 次下载 | 免费
- 7bq2060AEVM-001和bq2060AEVM-002用户指南
- 541.51KB | 次下载 | 免费
- 8具有有源箝位复位功能的48V至3.3V正激转换器
- 317.58KB | 次下载 | 免费
本月
- 12024PMIC市场洞察
- 2.23 MB | 162次下载 | 免费
- 2开关电源设计原理手册
- 1.83 MB | 44次下载 | 免费
- 3FS5080E 5V升压充电两串锂电池充电管理IC中文手册
- 8.45 MB | 23次下载 | 免费
- 4OAH0428最新规格书(中文)
- 2.52 MB | 15次下载 | 7 积分
- 5DMT0660数字万用表产品说明书
- 0.70 MB | 13次下载 | 免费
- 6UC3842/3/4/5电源管理芯片中文手册
- 1.75 MB | 12次下载 | 免费
- 7ST7789V2单芯片控制器/驱动器英文手册
- 3.07 MB | 11次下载 | 1 积分
- 8慧荣SM2263XT开卡软件-B16_B17_FW_S0614B0_RDT_S0617A
- 3.03 MB | 10次下载 | 5 积分
总榜
- 1matlab软件下载入口
- 未知 | 935119次下载 | 10 积分
- 2开源硬件-PMP21529.1-4 开关降压/升压双向直流/直流转换器 PCB layout 设计
- 1.48MB | 420061次下载 | 10 积分
- 3Altium DXP2002下载入口
- 未知 | 233084次下载 | 10 积分
- 4电路仿真软件multisim 10.0免费下载
- 340992 | 191367次下载 | 10 积分
- 5十天学会AVR单片机与C语言视频教程 下载
- 158M | 183335次下载 | 10 积分
- 6labview8.5下载
- 未知 | 81581次下载 | 10 积分
- 7Keil工具MDK-Arm免费下载
- 0.02 MB | 73807次下载 | 10 积分
- 8LabVIEW 8.6下载
- 未知 | 65987次下载 | 10 积分
评论
查看更多